About this item

• LARGE CAPACITY - Sovol drying box can accommodate two rolls of filament less than 70mm in width or a roll of filaments less than 150mm wide. When heating, open the PTFE joints on the top of the box so that the moisture evaporates.
• GOOD DRYING PERFORMANCE: Wet 3D printing filament causes tension, clogging, poor adhesion and shifting of layers. Sovol 3D filament drying box keeps the filament dry and restores the performance of FDM filaments. The two filament outlets must remain open during the drying process so that dry moisture can escape
• Real-time temperature and humidity monitoring inside: shows the humidity and temperature in the dry box in real time. The temperature can be adjusted between 40 °C, 45 °C and 50 °C, the drying time is 6-12 hours. If you use SH01 in a room with room temperature below 16℃, the temperature in the drying box does not reach 50℃. But don't worry, this does not affect the drying effect
• Excellent sealed filament storage box: reduces moisture inside the box by heating and drying. It can store wires for a long time without electricity and protect the wires from moisture and dirt. You can put 4 desiccant bags (not included) into the drying box to improve drying efficiency and quality.
• Optimized heating method: Hot air heating makes drying more efficient. The unique design of the fan in the box corresponds to the principle of air thermodynamics, and the filament is heated more evenly.
• Tips: Place the wire at the outlet of the wire. Note that the direction is counterclockwise so that the coil can feed better below. If there are two errors (E0 and E1) on the screen, open the drying box and check all the cable connectors on the motherboard for damage or loose space. If you have any problems, please feel free to contact us. We will send you a replacement.